Say goodbye to sensor spots.

Cleaning & Service

Sensor cleaning for all cameras, including both wet and dry cleaning.
Unfortunately, sensors, especially in mirrorless systems, get dirty very easily. Therefore, before every job, we check all equipment used for contamination and operational readiness.

So, we will not run out of cameras, lenses, memory cards, or batteries. Everything is available at least twice, and this also applies to your files until the project is completed. Essentially, we have all files from the last 10 years in backup.

We are one of the few points of contact when it comes to learning how to clean yourself. We also gladly check the firmware of cameras and lenses during our training sessions and assist with updates.

Cleaning is usually possible within 15 minutes. We always first examine the sensor with a loupe. If the camera's internal sensor cleaning does not yield results, we try to remove small dust particles, etc., with a blower. If that also doesn't work, we use Visible Dust Plus sensor cleaner and swabs to clean the sensor as gently as possible. We have not had good experiences with other products, especially with mirrorless cameras. We purchase cleaners in bulk, which helps to offset the cost compared to cheaper cleaners that, in our experience, do not work with mirrorless systems.